Analysis of common problems in the maintenance process of cycloid reducer
(1) The tightness and concentricity of the coupling parts of the reducer are very important for the operation of the reducer. It is necessary to control the two indicators of tightness and concentricity, so as to effectively avoid the equipment caused by the flying torque force. serious damage.
(2) It is necessary to regularly check the basic equipment conditions of the reducer, such as equipment installation, screw fixing, operation status, etc., to ensure that the reducer can complete the balanced movement, and adjust the unreasonable screws in the proper position or reinstall them.
(3) The oil volume of the reducer should be controlled within a specification range, and if it is lower than this specification, it should be increased, neither too high nor too low, to ensure that the reducer can operate normally.
(4) After the reducer has been used for a period of time, the new oil should be replaced as needed, and the metal powder in the reducer should be cleaned, but it should be noted that the amount of oil involved should ensure that the reducer can complete the normal operation, and can maximize the smooth operation. effect.
Mobile: 138-2653-6508 (Manager Liu)
150-1349-1658 (Mr. Liu Rangbo)
Email: 289880710@qq.com
Address: No. 4653, Tangwei Community, Gongming Street, Guangming District, Shenzhen (Brother Building)
WeChat scan |
Mobile official website |