Requirements for the withstand voltage test of the reducer

Do you understand the reducer? If you often pay attention to the news information of our website, I believe that many friends know the answer. Today, I will tell you about the requirements of the pressure resistance test of the reducer:

1. Rotor winding: During the handover experiment, take 1.5 times the extra voltage for the irreversible rotor and 3 times the extra voltage for the reversible rotor.

2. Stator winding: During the handover experiment, take 1 kV for the extra voltage of 0.4 kV and below, and 10 kV for the extra voltage of 6 kV; for the reducer in operation, and for those not replaced during overhaul Or the reducer that partially replaces the stator winding shall take 1.5 times the extra voltage, but shall not be lower than 1000 volts; the reducer that completely replaces the stator winding shall take 2 times the extra voltage plus 1000 volts, but shall not be lower than 1500 volts; less than 100 kilowatts For important low-voltage reducers, the communication withstand voltage test can be tested with a 2500-volt megohmmeter.

The requirements for the pressure resistance test of the reducer have been introduced, and your needs are our ultimate goal and pursuit. Sincerely thank you for reading, I hope you will get some harvest.